powermonkey
Member
Is there any special steps i have to take to tell directsoft or the plc to use stage logic (rll?).
+------+
|ISG S0|
+------+
|
|--]X7[-----------(JMP S1)
|-----------------(END)
+------+
|SG..S1|
+------+
|--]X5[-----------(JMP S1)
|
If i run the following program and flip X7, it will highlight S1, however it won't process any of the lines in S1. So when i reset X7 (to stay out of a loop) and flip X5, it will sit in S1. Any ideas? Is there something wrong with my synthax, is there something that i have to setup in directsoft? Im truly lost here.
+------+
|ISG S0|
+------+
|
|--]X7[-----------(JMP S1)
|-----------------(END)
+------+
|SG..S1|
+------+
|--]X5[-----------(JMP S1)
|
If i run the following program and flip X7, it will highlight S1, however it won't process any of the lines in S1. So when i reset X7 (to stay out of a loop) and flip X5, it will sit in S1. Any ideas? Is there something wrong with my synthax, is there something that i have to setup in directsoft? Im truly lost here.