I am new starter on panel view 550 and panel builder.based on the panel builder 32 manual I have created only one screen to start and stop a bit to represent my output on slc 500 fixed style.I have only used internal bits .The plc program and panel builder program is verified and there is no error .
I have connected the slc 500 and panel builder through dh 485 protocol and I have no problem with communication .The problem now is that the fault indicator on the pv 500 screen is flashing which i do not know what is it and every time i do down load to panel view pb 32 on the computer indicates illegal operation and program closes remind you this is very old computer 100 mega hertz processor with 24 mb ram
perhaps one of you gentelman can help and advice me to correct the problem.
thanks
MOHSEN
I have connected the slc 500 and panel builder through dh 485 protocol and I have no problem with communication .The problem now is that the fault indicator on the pv 500 screen is flashing which i do not know what is it and every time i do down load to panel view pb 32 on the computer indicates illegal operation and program closes remind you this is very old computer 100 mega hertz processor with 24 mb ram
perhaps one of you gentelman can help and advice me to correct the problem.
thanks
MOHSEN