The Plc Kid
Member
I have a 30 hp ac motor connected to a powerflex 700s ac drive the motor has a 1024ppm encoder.
It is running but in the wrong direction and when i swap t1,t2,t3 to change the direction at the drive or motor it still goes in the same direction but jerks? Why?
I think it has something to do with the encoder?
How can i get it going in the right direction?
It is running but in the wrong direction and when i swap t1,t2,t3 to change the direction at the drive or motor it still goes in the same direction but jerks? Why?
I think it has something to do with the encoder?
How can i get it going in the right direction?