iknowsomeplc
Member
We are using 1794 -IJ2 Flex IO modules for taking Encoder feedbacks from Hubner- Berlin Encoders. When we are connecting one channel , the readings are good. The supply voltage from the module - to - Encoder drops to 5.6 VDC but it still works and we get the readings OK. ( the 24vdc supply at the Power Supply end stilll measures 24VDC !!).
But the moment we connect 2nd encoder to 2nd channel , both the readings are gone . I understand that the supply voltage 24vdc folds back inside the module ( In IJ2 ,the encoder supply has to routed through the module only)
The details of Encoder Name Plate is :
HUBNER - BERLIN
MODEL : POG9GD 150
Incremental Encoder
9-30 VDC
IP56
Current Intake : 22 mA
Anybody knows solution for this?
But the moment we connect 2nd encoder to 2nd channel , both the readings are gone . I understand that the supply voltage 24vdc folds back inside the module ( In IJ2 ,the encoder supply has to routed through the module only)
The details of Encoder Name Plate is :
HUBNER - BERLIN
MODEL : POG9GD 150
Incremental Encoder
9-30 VDC
IP56
Current Intake : 22 mA
Anybody knows solution for this?