Hi,
I'm using a PV 1000 to control an SLC5/04 plc, so far everything has been working ok on all 10 equipments (is a production line), then I modified the program on the first press to add another sensors, I downloaded the program to the otherones and everything is fine.
But on the las press when I download the program and run it it gives me an error and on the S:5 (Overflow trap) and on the PV appears an error 208 (unable to communicate to plc).
I already checked the controller and channel configuration and everything is ok, can anyone tell why is this happening?, I really prefer to download the program from another plc of the line than to make all the changes again... (I already try with all the other plc's program and still get the errors)
Thanks
Juan
I'm using a PV 1000 to control an SLC5/04 plc, so far everything has been working ok on all 10 equipments (is a production line), then I modified the program on the first press to add another sensors, I downloaded the program to the otherones and everything is fine.
But on the las press when I download the program and run it it gives me an error and on the S:5 (Overflow trap) and on the PV appears an error 208 (unable to communicate to plc).
I already checked the controller and channel configuration and everything is ok, can anyone tell why is this happening?, I really prefer to download the program from another plc of the line than to make all the changes again... (I already try with all the other plc's program and still get the errors)
Thanks
Juan