I have zero prior experience with this software (Crimson 3.0) and hardware (Graphite G09, Graphite GMUIN4, L-Gage LE550 Laser Sensor), and am looking for some help in getting it set up properly. Again, I have next to no experience with this stuff so please try to go easy on me with any jargon .
I'm trying to measure the outer diameter (OD) of a cylindrical object (pipe) that is moving down a conveyer system while also rotating. I have the set up figured out, but need some help with the Crimson 3.0 software.
I have everything hooked up, and can display the OD on the screen of the Graphite, but I want to have a rolling average instead of the real time measurement. The measured surface is pretty bumpy and uneven, so a rolling average would be much more useful than the real time value.
If anyone that has experience with this software can help me out it would be greatly appreciated!
I'm trying to measure the outer diameter (OD) of a cylindrical object (pipe) that is moving down a conveyer system while also rotating. I have the set up figured out, but need some help with the Crimson 3.0 software.
I have everything hooked up, and can display the OD on the screen of the Graphite, but I want to have a rolling average instead of the real time measurement. The measured surface is pretty bumpy and uneven, so a rolling average would be much more useful than the real time value.
If anyone that has experience with this software can help me out it would be greatly appreciated!