sachincool786
Member
Dear Experts!!!!
I want to communicate my "XG-8000 Series Keyence Vision camera" with Mitsubishi Q06UDV PLC over RS232C non-protocol mode.
My configuration is like :
PLC CC-link Master module---------------- cc-link to RS232C cc-link cable converter (AJ65BT-R2N)
AJ65BT-R2N is connected to XG8000 Series controller over RS232C port-1.
Can anyone please tell me the commands, how can i change program, change variable etc. from PLC.(or have any manual regarding PLC command please forward)
If you have any sample program please forward it to [email protected]
Thank You.
I want to communicate my "XG-8000 Series Keyence Vision camera" with Mitsubishi Q06UDV PLC over RS232C non-protocol mode.
My configuration is like :
PLC CC-link Master module---------------- cc-link to RS232C cc-link cable converter (AJ65BT-R2N)
AJ65BT-R2N is connected to XG8000 Series controller over RS232C port-1.
Can anyone please tell me the commands, how can i change program, change variable etc. from PLC.(or have any manual regarding PLC command please forward)
If you have any sample program please forward it to [email protected]
Thank You.