patil.inst
Member
Dear All,
I am using parker 690series drive.
I am using modbus rtu protocol.
Configuration used: Laptop-RS232 to RS485 converter- Drive.
Settings kept in drive are:
Modbus rtu,RS485,parity-none,baud rate-9600.
Mode: 2-wire
In order to check modbus RTU address area i m using Modscan 32 software.
However i am getting error Invalid slave response.
Led indication on drive: Network led flashing.
(Its a new drive, i have tested it on 2 drives both new)
How to check? I do not want to check through dse lite software. It works.
I will communicate drive with third party controller.
I am using parker 690series drive.
I am using modbus rtu protocol.
Configuration used: Laptop-RS232 to RS485 converter- Drive.
Settings kept in drive are:
Modbus rtu,RS485,parity-none,baud rate-9600.
Mode: 2-wire
In order to check modbus RTU address area i m using Modscan 32 software.
However i am getting error Invalid slave response.
Led indication on drive: Network led flashing.
(Its a new drive, i have tested it on 2 drives both new)
How to check? I do not want to check through dse lite software. It works.
I will communicate drive with third party controller.