sailerman
Member
I have 2 identical systems that have the AB SLC500 Basic card in them.
I system stopped working and the issue was traced back to the card.
Switching cards from one system to the other, the problem goes with the card.
New card and blank eprom chip arrives.
I can not figure out how to pull the program from the working side to upload onto the new card.
I am using an emulator and am able to see the introduction remarks from the allen bradley.
ie.
SLC 500 BASIC Module - Catalog Number 1746-BAS
Firmware release: 7.00
Allen-Bradley Company, Copyright 1989 - 1999
All rights reserved
READY
>
Attempting to download at this point leads to ERROR: BAD SYNTAX.
I've tried all the various "modem" downloads and options available.
Any help in pulling the working program would be greatly appreciated.
I system stopped working and the issue was traced back to the card.
Switching cards from one system to the other, the problem goes with the card.
New card and blank eprom chip arrives.
I can not figure out how to pull the program from the working side to upload onto the new card.
I am using an emulator and am able to see the introduction remarks from the allen bradley.
ie.
SLC 500 BASIC Module - Catalog Number 1746-BAS
Firmware release: 7.00
Allen-Bradley Company, Copyright 1989 - 1999
All rights reserved
READY
>
Attempting to download at this point leads to ERROR: BAD SYNTAX.
I've tried all the various "modem" downloads and options available.
Any help in pulling the working program would be greatly appreciated.