drive troubleshooting

ganutenator

Lifetime Supporting Member
ganutenator
Join Date
May 2002
Location
kansas
Posts
1,440
Is it possible to see in an ATV212 if it is getting the frequency command via modbus?
For example: In the ATV312 you can go to FRH under the monitor menu and see it.

We are writing the rpm ref to the ATV212 in register 16#FA13.
 

Similar Topics

J
AB Ultra Master software download OR Ultra 200 Servo Drive troubleshooting help
Our Allen Bradley Ultra Series 200 Digital Servo Drive has been faulting out without providing a fault signal. After about 15 minuets of...
Replies
0
Views
2,089
jared_turner@brady
J
S
AC Drive Troubleshooting.
Is there a way to know what to look for on either the AC output or DC buss to determine if a drive is malfunctioning?
Replies
1
Views
1,614
jraef
J
T
ABB Acs 800 U1 Drive Troubleshooting
Does anyone know where I can get a troubleshooting manual for ABB ACS 800 U1 drives? I don't know what to check to determine if they are fully...
Replies
1
Views
3,139
GaryS
G
A
Troubleshooting an old DC variable speed drive
Short Question - I am looking for a datasheet or any other available information on a Westinghouse class 9022 DC motor drive. Google has been most...
2 3
Replies
32
Views
17,252
leitmotif
L
Russ
HELP! Robicon CSI Drive Problem... 'Over Voltage'... need troubleshooting advice...
Have an 800HP Robicon CSI drive (ID CSI 456980.00 fyi).. and when the drive runs at/above 44Hz I get over voltage faults. I've looked at the clamp...
Replies
7
Views
3,608
Russ
Russ
Back
Top Bottom