ankit_patel291
Member
Hi,
I am working on Mitsubishi PLC project.I am using two PLC below.
PLC 1 - FX3U (Master)
IP : 192.168.0.10
PLC 2 - FX3g (Slave)
IP : 192.168.0.20
I am connecting both PLC via ethernet module FX3U-ENT. I would like to transfer bit M0 to M15 from FX3G (Slave) PLC to FX3U (Master) PLC every scan cycle. FYI I am not sending any data from Master to Slave.
Please try to help me to sort it out this issue ASAP. If you have any coding example then it will really help me.
Regards,
Ankit Patel
I am working on Mitsubishi PLC project.I am using two PLC below.
PLC 1 - FX3U (Master)
IP : 192.168.0.10
PLC 2 - FX3g (Slave)
IP : 192.168.0.20
I am connecting both PLC via ethernet module FX3U-ENT. I would like to transfer bit M0 to M15 from FX3G (Slave) PLC to FX3U (Master) PLC every scan cycle. FYI I am not sending any data from Master to Slave.
Please try to help me to sort it out this issue ASAP. If you have any coding example then it will really help me.
Regards,
Ankit Patel