A quick background..
I was told by our local AB supplier that i need to replace my basic module, when our machine powers down, even momentarily, we lose the program. (replaced battery already, problem still existed)
So, we received a replacement module (from a working machine).
I matched the jumpers on to the current module, installed it.
using hyperterminal, i called the program from the old module, loaded it and when executing run command received the error "a-stack error in line 180"
I replaced the module with the old one again, did same procedure and it loads flawlessly...
Need some help here, not an expert by any means..
Does the new (used) module need to be factory reset?
Are the jumper settings supposed to be same?
Is my new module no-good?
Looking forward to your comments
Thanks
I was told by our local AB supplier that i need to replace my basic module, when our machine powers down, even momentarily, we lose the program. (replaced battery already, problem still existed)
So, we received a replacement module (from a working machine).
I matched the jumpers on to the current module, installed it.
using hyperterminal, i called the program from the old module, loaded it and when executing run command received the error "a-stack error in line 180"
I replaced the module with the old one again, did same procedure and it loads flawlessly...
Need some help here, not an expert by any means..
Does the new (used) module need to be factory reset?
Are the jumper settings supposed to be same?
Is my new module no-good?
Looking forward to your comments
Thanks