Fernando_PLC
Member
Hi everyone.
I am new here in this page. This is my first post. I hope to receive the best suggestions and tips wanting also to collaborate according to my experience.
I bought an used SLC 503 with controller and 8 modules (3 out of them outputs). I am also working with a Virtual Machine.
To test the outputs I did a small program. When I run it, everything is OK except that there is no power in the outputs activated. The ladder runs OK, the module (physical) shows the leds of the activated outputs, but when checking the voltage with a multimeter in the outputs, there's no voltage at all!
See the pic here
https://drive.google.com/file/d/10NRp0qrZnB1GeFEb6OYcVbDSUmLSmmLO/view?usp=sharing
Thanks in advance for your help and comments.
I am new here in this page. This is my first post. I hope to receive the best suggestions and tips wanting also to collaborate according to my experience.
I bought an used SLC 503 with controller and 8 modules (3 out of them outputs). I am also working with a Virtual Machine.
To test the outputs I did a small program. When I run it, everything is OK except that there is no power in the outputs activated. The ladder runs OK, the module (physical) shows the leds of the activated outputs, but when checking the voltage with a multimeter in the outputs, there's no voltage at all!
See the pic here
https://drive.google.com/file/d/10NRp0qrZnB1GeFEb6OYcVbDSUmLSmmLO/view?usp=sharing
Thanks in advance for your help and comments.