plemonse
Member
I'm trying to program a Panelview Plus 600 for a Micrologix 1100 using ethernet. I have set the PLC address to 10.188.13.60 and the Panelview to 10.188.13.61. When I use RS Linx to see if its communicating through a ethernet switch I show the Micrologix but nothing for the Panelview. I'm not sure if my problem lies in the communication network of my application for RS View.
I added a device for the ethernet as Micrologix 1100-LEC as 10.188.13.60 and another device for ethernet use as Panelview Plus 600 with an IP of 10.188.13.61. I then copy local into runtime and then create a runtime application. But once I run my .mer file in the panelview it shows errors all over the screen, where it should have status messages.
I've tried many different ways, but with no success. I still think the problem is in the RS View comminucation, but don't know why.
Any help would be GREAT.
I added a device for the ethernet as Micrologix 1100-LEC as 10.188.13.60 and another device for ethernet use as Panelview Plus 600 with an IP of 10.188.13.61. I then copy local into runtime and then create a runtime application. But once I run my .mer file in the panelview it shows errors all over the screen, where it should have status messages.
I've tried many different ways, but with no success. I still think the problem is in the RS View comminucation, but don't know why.
Any help would be GREAT.
Last edited: