forqnc
Lifetime Supporting Member
Hi all,
I've only been learning Omron for a couple of months now. Used AB and Automation Direct. Today I went to start a program and set up my I/O on the rack. When I selected my PTS15 it was addressed automatically to 2010. But this causes the CPU to inform me there is no card, and gives me a non fatal error with the red ERH light on the card lit.
Now if I go to a working program, which is addressed at 2100 the PLC is fine.
Is there away to manually change this value?
I've only been learning Omron for a couple of months now. Used AB and Automation Direct. Today I went to start a program and set up my I/O on the rack. When I selected my PTS15 it was addressed automatically to 2010. But this causes the CPU to inform me there is no card, and gives me a non fatal error with the red ERH light on the card lit.
Now if I go to a working program, which is addressed at 2100 the PLC is fine.
Is there away to manually change this value?
Last edited: