richleva Member R Join Date Sep 2012 Location ontario Posts 79 Oct 20, 2017 #1 Hello, I created a heartbeat in RSlogix 500, just a bit that toggles on and off every 3 seconds. How can I monitor the heartbeat using Vijeo designer? Any ideas?
Hello, I created a heartbeat in RSlogix 500, just a bit that toggles on and off every 3 seconds. How can I monitor the heartbeat using Vijeo designer? Any ideas?
gclshortt Member Join Date Dec 2014 Location Ontario Posts 3,217 Oct 22, 2017 #2 http://www.plctalk.net/qanda/showthread.php?t=97819 The above thread may help you out in establishing communications. The heartbeat should be a bit that is set in the PLC. The device that is communicating to the PLC will then reset the bit. This creates the on / off action of the heatbeat. Regards,
http://www.plctalk.net/qanda/showthread.php?t=97819 The above thread may help you out in establishing communications. The heartbeat should be a bit that is set in the PLC. The device that is communicating to the PLC will then reset the bit. This creates the on / off action of the heatbeat. Regards,