jthornton
Member
I had a fellow programmer call me the other day with a problem he was having on an AB Micrologix 1500. He had just written the code and had a counter that when the input (a limit switch) was closed the counter would start to count up instead of counting one it kept counting. I never counld get him to send me the code. I was wondering what could cause this? He said that he was going to write the code over again and I never heard back from him so that makes me think that it was in his code instead of a physical problem like loose wire at a terminal etc.
Is there any way to increment a counter in code besides the input going high?
Any one run across this before?
Thanks
Is there any way to increment a counter in code besides the input going high?
Any one run across this before?
Thanks