Allen Bradley Poll: AOI vs UDTs

!Poll= Tools

I agree the correct answer is the screwdriver. Get a good 2.5mm tweeker and its strong enough to torque, but small enough for most small din TBs... And even some prybarring, just as long as your cool with an offset shaft. Seriously though, thankyou theColonel26, Jeev, and PreLC for the useful answers.

OMFG I didn't think this would turn into a "Boyz aren't grlz" twitter post. Lets take camping for instance, if you go camping with only 3 tools, Im only asking whats successful for you and WHY. IMHO: 1)Leatherman 2)fire source .....and JackDaniels, hey who knows when they're doing to shut down interstate travel again, thank you Corona...
 
Create the UDT Structure; Create a AOI, include the UDT structure; Create second AOI; Include first AOI; Nested UDT's; play with input/output tags to connect everything
 

Similar Topics

Hi how's it going. Was just wondering if someone could help me out. Recently one of the guys over on the LinuxCNC forums put me onto getting an...
Replies
15
Views
257
Hello, Does anyone have one of these cables and willing to open the case so I can see the cable connections inside? 2707-NC5 I have sourced the...
Replies
3
Views
85
Currently trying to find: micrologix ethernet interface 1761-NET-ENI AIC to micrologix 761-CBL-AM00 Ser C cable These are used for micrologix...
Replies
3
Views
133
in allen bradley kinetix 300 drive first E31 error shows after resting drive E11 error occurs need solution to reset E11 fault code
Replies
4
Views
174
Hi, I have a ControlLogix system with 1756-IF16 analogue inputs. I can't scale the inputs at the card as there is a requirement to facilitate...
Replies
14
Views
460
Back
Top Bottom