DoubleJ Member D Join Date Oct 2017 Location midwest Posts 13 Feb 25, 2020 #1 Anyone used an EZ Automation plc/hmi? I'd like to utilize the RTC and need assistance on how to use it in the ladder logic.
Anyone used an EZ Automation plc/hmi? I'd like to utilize the RTC and need assistance on how to use it in the ladder logic.
gclshortt Member Join Date Dec 2014 Location Ontario Posts 3,217 Feb 25, 2020 #2 https://assets.omega.com/manuals/M_EZPLC_SOFT.pdf In the above manual Chapter 3 - Programming EZPLC will show you the system registers. SR10 to SR20 will contain the information about the RTC. You mentioned in the title of the post the Mini version. https://www.ezautomation.net/HMI-PLC-All-in-One/EZTouchminiPLC/pdfs/EZTouchMiniPLC%20Manual.pdf The manual does not document the same registers as mentioned above. I would contact the manufacturer to see if this is possible. I hope this helps you out. Regards,
https://assets.omega.com/manuals/M_EZPLC_SOFT.pdf In the above manual Chapter 3 - Programming EZPLC will show you the system registers. SR10 to SR20 will contain the information about the RTC. You mentioned in the title of the post the Mini version. https://www.ezautomation.net/HMI-PLC-All-in-One/EZTouchminiPLC/pdfs/EZTouchMiniPLC%20Manual.pdf The manual does not document the same registers as mentioned above. I would contact the manufacturer to see if this is possible. I hope this helps you out. Regards,