Good Afternoon,
We had a few power outages yesterday . I had several " Hold In " conditions that the operator selects on her HMI . They are just like " Hold In " contacts like a hardwire stop / start .
I thought that that "condition " would stay " True " . How would I insure that " Hold In " condition would stay true after a power loss ?
If I put a Latch / Unlatch condition that should keep the condition that I had before the outage , and it should remain when power returns , correct ?
Thanks so much for your help .
We had a few power outages yesterday . I had several " Hold In " conditions that the operator selects on her HMI . They are just like " Hold In " contacts like a hardwire stop / start .
I thought that that "condition " would stay " True " . How would I insure that " Hold In " condition would stay true after a power loss ?
If I put a Latch / Unlatch condition that should keep the condition that I had before the outage , and it should remain when power returns , correct ?
Thanks so much for your help .