kapooski2012
Member
On my trainer I’m using a 3 phase telemechanique contactor without holding contacts. The inputs on the contactor are not being used except for L1 which I’m using in a loop to keep the coil energized. How do I land the wires on the PLC? Input 0 get the stop wire, input 1 gets the start wire I then take a wire direct from the line side to the L1 , to keep the coil energized, I haven’t ran the program yet…I figure to put it to the forum first, I’m sure there is someone out there that has wired a contactor that did not have auxiliary contacts, did I land the wires on the PLC at the right spot? Or is there another way?