Sparky
Member
Hey guys, I am currently putting together a small automated system that controls a 12Vdc valve and 12Vdc motor. The whole system runs off of a 12Vdc battery (basically a car battery) that is charged via a 40W solar panel.
Here are my components:
Micro810
Panelview 300C
12Vdc ball valve (33W max draw)
12Vdc mixer (26W max draw)
12Vdc battery 600mha
40W solar panel
Battery charger/regulator
So here is my question: What kind of voltage/current regulator would you recommend using for the supply power to the Panelview and PLC. The ball valve and mixer are both rated to run directly from the battery. For obvious reasons I do not want to run the power directly from the battery to the PLC and Panelview. Thanks for your suggestions.
Here are my components:
Micro810
Panelview 300C
12Vdc ball valve (33W max draw)
12Vdc mixer (26W max draw)
12Vdc battery 600mha
40W solar panel
Battery charger/regulator
So here is my question: What kind of voltage/current regulator would you recommend using for the supply power to the Panelview and PLC. The ball valve and mixer are both rated to run directly from the battery. For obvious reasons I do not want to run the power directly from the battery to the PLC and Panelview. Thanks for your suggestions.