asdf6
Member
Anyone have problems with the absolute offset of an axis controlled by a 1756-M02AS being erased and/or being a large number that doesn’t relate to the motion coordinate system?
1756-M02AS Absolute offset erased
- Thread starter asdf6
- Start date
Similar Topics
Hi everyone, I'm looking to modify some motion controls. There's a hoist that picks up to 8 railway ties, weighing up to 300 lbs each, which then...
Hello all,
I am trying to figure out whether the M02AS card actually has a deadband compensation. As you may know, in the Axis properties there...
I've got a 1756-M02AS card installed, along with the SSI encoder. I was able to get the Axis to tune, but after I couldn't get it to run a MAJ or...
Hi all
I have a ControlLogix 1756-L71SP that i want to use for general PLC applications, not safety. I am running Studio5000 v33, i can't...
Hi, I have a ControlLogix system with 1756-IF16 analogue inputs. I can't scale the inputs at the card as there is a requirement to facilitate...