Hi,
I'm after a little help please. I program 95% siemens PLCs, then once a flood I get a rockwell project - so I tend to go a little rusty/ get out of date.
I've been given a hardware spec from our controls team that specifies the following PLC structure:
1769-L16ER-BB1B CPU
1769-IQ16
1769-OB32
1769-IF8
1769-OF4
When I go into the studio 5000 (v30) - I specify the PLC in the 'create new project', but when I go to 'add modules' under either 'Point IO' or 'Expansion IO' on the bottom of the left hand menu, I can only select IO cards that begin with 1734?
Help would be much appreciated.
Thanks
Rob
I'm after a little help please. I program 95% siemens PLCs, then once a flood I get a rockwell project - so I tend to go a little rusty/ get out of date.
I've been given a hardware spec from our controls team that specifies the following PLC structure:
1769-L16ER-BB1B CPU
1769-IQ16
1769-OB32
1769-IF8
1769-OF4
When I go into the studio 5000 (v30) - I specify the PLC in the 'create new project', but when I go to 'add modules' under either 'Point IO' or 'Expansion IO' on the bottom of the left hand menu, I can only select IO cards that begin with 1734?
Help would be much appreciated.
Thanks
Rob