pcola
Member
I am using Windows XP through Serial Port Comm 1 and have connected to the AB 1771-DB/B with a null modem cable. I am using Hyperterminal to connect.
1200 Baud
8 Data Bits
No Parity
1 Stop Bit
Xon/Xoff Flow Control
Auto Detect Emulation
I can send a Ctrl-Y to put the card into command mode and can see the Transmit and Receive Lights flicker, but no response.
I am connect to PRT1
JW1 - Enabled
JW2 - 8KEEProm
JW3 - Normal
JW4 - PRT1 = Pgm, PRT2 = ASCII, DH485 = Run
JW5 - Backplane
JW6 - 9600
JW7 - Battery Disabled
Which program do I use for Send and Receive? Xmodem, Ymodem, Kermit?
I cannot get any response except putting the card into Command Mode and seeing the XMT/RCT PRT1 lights flicker
Thank you
1200 Baud
8 Data Bits
No Parity
1 Stop Bit
Xon/Xoff Flow Control
Auto Detect Emulation
I can send a Ctrl-Y to put the card into command mode and can see the Transmit and Receive Lights flicker, but no response.
I am connect to PRT1
JW1 - Enabled
JW2 - 8KEEProm
JW3 - Normal
JW4 - PRT1 = Pgm, PRT2 = ASCII, DH485 = Run
JW5 - Backplane
JW6 - 9600
JW7 - Battery Disabled
Which program do I use for Send and Receive? Xmodem, Ymodem, Kermit?
I cannot get any response except putting the card into Command Mode and seeing the XMT/RCT PRT1 lights flicker
Thank you