Hi all,
Im just Simatic S7 beginner.
So I just made a small connection and try to force all IO in My PLC project.
I made Viriable table and I put DI, DO AI and AO in to it.
And the configuration of each channel in this card i Put I 4-20mA already.
When i connect to CPU to monitor all IO.
I can do only for DI ,DO and AI.
but when i put new value to PQW 272 and press Ctrl+F9 their is no signal come from the channel.(measure on Pin 3 and )
So Any Idea about that? if yes please let me know.
Im just Simatic S7 beginner.
So I just made a small connection and try to force all IO in My PLC project.
I made Viriable table and I put DI, DO AI and AO in to it.
And the configuration of each channel in this card i Put I 4-20mA already.
When i connect to CPU to monitor all IO.
I can do only for DI ,DO and AI.
but when i put new value to PQW 272 and press Ctrl+F9 their is no signal come from the channel.(measure on Pin 3 and )
So Any Idea about that? if yes please let me know.