94 series markem imaje Printer (9405)

[ahmadk]

Dear Sir
I need your help if you can give me some solutions,
I have a Markem Imaje 9405 printer It works well,
but i need the right configuration to allow the printer to return response when i send any command by TCP/IP protocol ,
the old printers (9040) are working good and return response for any correct command that i send to it,
based on his network interface the command is correct but i think it is need special configuration that different than old one,
So if anyone can help me, I'd appreciate it
thx.​

 

[gclshortt]

http://www.plctalk.net/qanda/showthread.php?t=71394

The above post may help you out.
Regards,

 

[ahmadk]

http://www.plctalk.net/qanda/showthread.php?t=71394

The above post may help you out.
Regards,

thx for your help ,
I found the solution ,
it was simple ,just i was changed the printer configuration protocol form external variable to standard