ndzied1
Lifetime Supporting Member
Hi,
I have a guy out in the field working on an ABB ACS150 drive and having an issue. We are trying to get the drive set up for 0-10VDC analog command for 15 to 80 Hz. What is happening is that we are getting the 15 Hz at analog signals below about 20% and then the signal ramps up from there.
We have the switch on the front set to U for voltage input and parameters we think should work. Parameters we have set different from default are:
9902=1
9905=460
9906=0.8
9907=60
1105=80
1301=0
2007=15
2008=80
Any help greatly appreciated.
I have a guy out in the field working on an ABB ACS150 drive and having an issue. We are trying to get the drive set up for 0-10VDC analog command for 15 to 80 Hz. What is happening is that we are getting the 15 Hz at analog signals below about 20% and then the signal ramps up from there.
We have the switch on the front set to U for voltage input and parameters we think should work. Parameters we have set different from default are:
9902=1
9905=460
9906=0.8
9907=60
1105=80
1301=0
2007=15
2008=80
Any help greatly appreciated.
Last edited: