[email protected]
Member
Hello
i am trying to set up my ACS350 to dynamically brake a high inertia load.
i have noticed that there are a number of digital inputs that can be used to activate the drive remotely. see attached image
i am not sure how to set up the drive to dynamically brake a load. there is a start/stop digital input but also an accelerate/decelerate input. dose the drive automatically regenerate when the you activate the stop command or must you use the decelerate command?? i know you must disable the over voltage controller in order to use dynamic braking but i am not sure how to actually implement it physically
thanks in advance
i am trying to set up my ACS350 to dynamically brake a high inertia load.
i have noticed that there are a number of digital inputs that can be used to activate the drive remotely. see attached image
i am not sure how to set up the drive to dynamically brake a load. there is a start/stop digital input but also an accelerate/decelerate input. dose the drive automatically regenerate when the you activate the stop command or must you use the decelerate command?? i know you must disable the over voltage controller in order to use dynamic braking but i am not sure how to actually implement it physically
thanks in advance