Alstom Courier Protocol

ShaunCroman

Member
S
Join Date
Apr 2015
Location
UK
Posts
26
Hi- just wondering if anyone has had any dealings with the Alstom Courier protocol. I am looking at a legacy project which has a variety of equipment using K-bus (all Alstom/GE relays) connected to a KITZ201 module. The KITZ module is connected to a serial to Ethernet converter with its serial port set at 9600,8,2,n. I have tried getting this to work but no luck.. Citect has a driver for it but I suspect that the issue may not be with the OPC server- if anyone could give me any pointers on how to validate that there is data reaching the serial server it would be much appreciated

regards

Shaun
 

Similar Topics

S
Alstom Courier Protocol Gateway
I was wondering if anyone has ever had any success in integrating devices running the courier protocol (Alstom IEC870) into either Rockwell or...
Replies
0
Views
1,404
ShaunCroman
S
T
Software Alstom
hi everyone, i need help of comunity, need "The controlcad 4.1.2" or any other up version, because my copy its corrup and the laptop with the hard...
Replies
1
Views
913
goghie
G
U
Alstom/GE Controcad for P320
Hi All, I have an old XP laptop that has Controcad for GE/Alstoms P320 AVR. The laptop is on its last legs and we don't have the installation...
Replies
4
Views
2,799
Kgabo
K
geniusintraining
Alstom Alspa and GE
I received a email from a customer looking to support their Alstom Alspa PLC's I think GE bought them, my customer is wondering.... Guessing I...
Replies
5
Views
2,256
samir hamed
S
M
Read data from Alstom C80-35 PLC
My control system is built by Alstom, It uses Alstom Alspa P320. The communication bus is S8000-E. All PLCs are Alstom Alspa C80-35 (same as GE...
Replies
1
Views
4,017
nandoperu100
N
Back
Top Bottom