Any Help Full Tips about Analog

BHazen

Member
B
Join Date
Dec 2011
Location
Platteville, WI
Posts
2
Im trying to receive a signal from a H20 Keyence FT-W Series Temperature Sensor to a 1769-IF4I. I am using the add-on instruction SCP and my input isn't changing when the Sensor sees a temperatur increase. Im wondering if i need to jump a wire or resistor between CH+ and CH_iRtn? My Analog card is in slot four and I believe i have to use Local:4:I.CHData. Any help would be really appreciated.
 

Similar Topics

K
Need Help Modifying Citect Scada Historical Trend Variable Data
So i've been at this for a long while, i have Citect Scada 2018, i have full access to everything but i can't seem to find any option or...
Replies
0
Views
30
kreamsippycup
K
A
AOI or program help creation
Hi all, hope you are having a great day, I am in need of your help to create a AOI or program that does this kind of job: I have a IO Link...
2
Replies
20
Views
292
drbitboy
drbitboy
D
Please help me make this ladder diagram
please help me . I have to make this ladder diagram and I can’t figure it out :(
Replies
12
Views
352
mburtis
M
D
Help with TCSEGDB23F24FA M340 Modbus Plus Proxy Module
Hi Everyone, i was hoping for a little help with this module. i have data that needs to be read from a different plc through the Modbus plus...
Replies
11
Views
231
davexr
D
B
A little Ladder logic help
Hello, I am trying to replicate a piece of logic on the PLC5 onto an SEL RTAC. I am using ladder on SEL and FBD. I am having issue on the ladder...
Replies
13
Views
238
BeepBob
B
Back
Top Bottom