kf5pv
Member
Hey guys, any ideas? fault code is 40. pdf file says "The AS-i master is in offline phase." It also says " if the AS-i LED is off that the AS-i is not suffeciently powered. I dont have any power problems...I looked at the status bits in the data tables and there are two other faults. one is a configuration fault and the other is a periphery fault. this is a bihl wiedamnn card. This has happened once before and it went away and I never knew what happened. also when I press and hold the mode button for 5 seconds it doesnt go into configuration mode as I think it should. this is a two channel unit and channel two is fine but one is not. I have unplugged the network cables cycled power on the power supply and a few other tricks but no luck. going to stop the process in about 1 hour and cycle power on the rack. (which has been done earlier with no luck)
any help would be fantastic.
If I were two-faced, would I be wearing this one?
Abraham Lincoln
any help would be fantastic.
If I were two-faced, would I be wearing this one?
Abraham Lincoln