Peter Nachtwey
Member
This webinar was held yesterday. I didn't post a link to it. We had over 200 people attend it anyway.
There was more question and answers on this one.
https://forum.deltamotion.com/t/april-22-2020-delta-hydraulic-cylinder-tuning/734
This webinar is probably good for general motion control programming. Each type of system is different so knowing how to tune a temperature system doesn't necessarily apply to motion control. If I were doing it I would be a little more in depth.
The auto tuning get very close without much hassle.
There was more question and answers on this one.
https://forum.deltamotion.com/t/april-22-2020-delta-hydraulic-cylinder-tuning/734
This webinar is probably good for general motion control programming. Each type of system is different so knowing how to tune a temperature system doesn't necessarily apply to motion control. If I were doing it I would be a little more in depth.
The auto tuning get very close without much hassle.