Hello everyone!
I am in the middle of converting an RSLogix 500 program to RSLogix 5000. I made an array of INTS called B3 and have been using this to address my bits used in the 500 project. I have reached a BSL instruction whose "File" attribute is B3:6 in the 500 project but in 5000 it says you need to use a DINT. Any good ideas on how to accomplish this? I have attached a picture of the original instruction.
I am in the middle of converting an RSLogix 500 program to RSLogix 5000. I made an array of INTS called B3 and have been using this to address my bits used in the 500 project. I have reached a BSL instruction whose "File" attribute is B3:6 in the 500 project but in 5000 it says you need to use a DINT. Any good ideas on how to accomplish this? I have attached a picture of the original instruction.