Hello,
I am looking for a Keypad that can be attached to a CAN bus so I do not had to wire buttons to an input module. It is for a mobile aplication so it needs to be IP66, stand vibrations -25C to 50C etc. about 10 buttons preferably about 1*1"
Preferably CAN-OPEN but J1939 or layer 2 will do.
Found this:
http://www.grayhill.com/news/default.aspx?ArticleId=15
Seems good. Anyone have any experience?
Other suggestions??
I am looking for a Keypad that can be attached to a CAN bus so I do not had to wire buttons to an input module. It is for a mobile aplication so it needs to be IP66, stand vibrations -25C to 50C etc. about 10 buttons preferably about 1*1"
Preferably CAN-OPEN but J1939 or layer 2 will do.
Found this:
http://www.grayhill.com/news/default.aspx?ArticleId=15
Seems good. Anyone have any experience?
Other suggestions??