Comunication Telesis S7 300

[drakkenghost]

hey , can anyone help me .

I have a siemens plc s7 300 with a telesis pinstamp dot pen model tmp3000 and the controller tmc300.

I have a new lazer marking that i replace the pinstamp , the laser is telesis F160 with merlin 2 and module for i/o .

the problem i have, how can i change the response code in both machines i have in host extended protocol.

 

[foggers]

hey , can anyone help me .

I have a siemens plc s7 300 with a telesis pinstamp dot pen model tmp3000 and the controller tmc300.

I have a new lazer marking that i replace the pinstamp , the laser is telesis F160 with merlin 2 and module for i/o .

the problem i have, how can i change the response code in both machines i have in host extended protocol.

Hi,

new here today. Did you ever get this sorted out? (I see it was a few months ago. I can probably help, even if the answer is "no"
Cheers


Foggers

 

[seele]

hey , can anyone help me .

I have a siemens plc s7 300 with a telesis pinstamp dot pen model tmp3000 and the controller tmc300.

I have a new lazer marking that i replace the pinstamp , the laser is telesis F160 with merlin 2 and module for i/o .

the problem i have, how can i change the response code in both machines i have in host extended protocol.

Hi,

I'm trying to communicate with Telesis TMC470 controller via TCP/IP with a Siemens S7-300 PLC. How was the communication with TMC300 in your old project? Did you find any solution?

Thank you.