HoldenC
Member
Today I was trying to upload the logic from a SLC500 system. I worked with 2 processors and I had the same results with each of them.
I was using this cable here: (and this is the first time ive used it)
https://www.plccable.com/allen-bradley-usb-1747-cp3-1756-cp3-slc-5-03-04-and-clx/
First of all I used a db9 female to female cable because the cable i bought had a male end, and so does the processor.
However, when connecting to the processor, Auto-Config keeps failing to find baud rate and parity bit.
What am I doing wrong ?
Should i just buy a gender changer plug to put on the PLC cable instead of the db9 to db9 cable ?
I was using this cable here: (and this is the first time ive used it)
https://www.plccable.com/allen-bradley-usb-1747-cp3-1756-cp3-slc-5-03-04-and-clx/
First of all I used a db9 female to female cable because the cable i bought had a male end, and so does the processor.
However, when connecting to the processor, Auto-Config keeps failing to find baud rate and parity bit.
What am I doing wrong ?
Should i just buy a gender changer plug to put on the PLC cable instead of the db9 to db9 cable ?