feraidoon2000
Member
yes
I think it may an uncorrected adjust in project case that but I cant find it
I think it may an uncorrected adjust in project case that but I cant find it
Control Techniques Unidrive M700 - Modbus/TCP slave address
- Thread starter g.mccormick
- Start date
Gene Bond
Member
At this point, I would try resetting to defaults and start over. Otherwise you have something else bad.
Similar Topics
Looking for a Modbus address manual for M700.
Modbus address is same as the Parameter number for 16Int parameters.
But it is different for 32Int...
I have a UD71 serial communications module I'm trying to use to access a Unidrive's parameters, and it claims in the manuals it can do "dumb...
System:
Drive: Control Techniques - Unidrive SP (Panel Mount)
Controller: NI cRIO
Power: Whole system runs off of a 3 phase 480V plug. There is...
Has anyone experience with Control Techniques Unidrive SP with profibus communication module? Is it possible to download parameters by the...
We have an EN214 base drive fitted with an FM3 module that has started to drop out of its program at random and then start again after a few...