krakenfan69
Lifetime Supporting Member
HI guys,
I have a project where I need to set a SD based off of 2 variables. Speed and Differential pressure. I have a table that has the speed setpoints down the left side and the diff press across the top. If I cross reference the two I get the flow rate setpoint. Is there a function that will allow me to create this table and do this cross reference for me? I've been searching but haven't pegged the right keywords just yet. This is to be done in RSLogix 5000 version 20.01 on a 1756-L74 processor.
Thanks for any help,
Kraken Fan #69
I have a project where I need to set a SD based off of 2 variables. Speed and Differential pressure. I have a table that has the speed setpoints down the left side and the diff press across the top. If I cross reference the two I get the flow rate setpoint. Is there a function that will allow me to create this table and do this cross reference for me? I've been searching but haven't pegged the right keywords just yet. This is to be done in RSLogix 5000 version 20.01 on a 1756-L74 processor.
Thanks for any help,
Kraken Fan #69