olias
Member
I have a project I'm working on that has two Cutler Hammer VFDs (1/2 hp, and 2hp), a Micrologix 1000, a couple of 24vdc inductive proxs and one 24vdc capacitive prox. Everything is fine untill I turn on the 2 hp drive. Then the cap. prox goes on. I tried taking another prox and when I just wired the brown and blue leads to the power supply, left the load wire hanging, and turned the drive on, the same thing happened. The motor leads go out one side of the panel and the proxs go out the other. And I'm already using an isolated power supply. Any suggestions? Thanks.
Olias
Olias