Hello All,
I am using a stepper motor controller by AMCI (SD17060E), and am using a SFC program to control an automatic cycle. My difficulty is that one of my transitions needs to use a "motion completed" status bit from the AMCI driver. Normally, this bit stays high, and when motion is occurring, it goes low. Since the command in the SFC to run the stepper drive is right before the "motion completed" transition, the motion will begin, and the transition of "motion complete" is still high, since the CPU has not updated the bit status from the AMCI. I COULD just use a TON in the ladder to delay longer than a scan to make sure my motion bit is in the right state, but that seems wrong.
Is there something simple that I am missing here?
Thanks!
Chip
I am using a stepper motor controller by AMCI (SD17060E), and am using a SFC program to control an automatic cycle. My difficulty is that one of my transitions needs to use a "motion completed" status bit from the AMCI driver. Normally, this bit stays high, and when motion is occurring, it goes low. Since the command in the SFC to run the stepper drive is right before the "motion completed" transition, the motion will begin, and the transition of "motion complete" is still high, since the CPU has not updated the bit status from the AMCI. I COULD just use a TON in the ladder to delay longer than a scan to make sure my motion bit is in the right state, but that seems wrong.
Is there something simple that I am missing here?
Thanks!
Chip