nightline
Member
Gents I've here a Kinetix 6000 servo system for playing / learning.
After a firmware update and rewiring it comes with error E35.
Probably after a wrong start-up sequence.
The manual tells me to measure the supply voltage or send the unit for repair to Rockwell.
Supply voltage from LIM is within spec. so the unit should be send for repair.
But this is to expensive for the purpose of the unit.
Has anyone experience with the repair of this type of error on this type of unit?
Or point me in a direction, what should I measure / check...??
Thanks in advance!
Jack
After a firmware update and rewiring it comes with error E35.
Probably after a wrong start-up sequence.
The manual tells me to measure the supply voltage or send the unit for repair to Rockwell.
Supply voltage from LIM is within spec. so the unit should be send for repair.
But this is to expensive for the purpose of the unit.
Has anyone experience with the repair of this type of error on this type of unit?
Or point me in a direction, what should I measure / check...??
Thanks in advance!
Jack