psychosunshine
Member
I am getting ready to upgrade a press from an Eddy Current to a VFD with a standard motor.
If any of you have previously done this. What kinds of things did you run in to? What things do I need to consider that I may be forgetting?
We are using 40HP Eddy's and I was going to use a 50HP Baldor EM4115T, with the new Yaskawa GA800 VFD(A1000 replacement). The shaft size and motor footprint is nearly identical.
What else do I need to worry about?
I was going to rely on Speed Search to deal with starting into a rotating load.
If any of you have previously done this. What kinds of things did you run in to? What things do I need to consider that I may be forgetting?
We are using 40HP Eddy's and I was going to use a 50HP Baldor EM4115T, with the new Yaskawa GA800 VFD(A1000 replacement). The shaft size and motor footprint is nearly identical.
What else do I need to worry about?
I was going to rely on Speed Search to deal with starting into a rotating load.