So I simulated the signal from the meter to the input card. Everything matches.
(4ma=0Gpm and 20ma=400Gpm).
With E&H i was able to simulate 4-20ma and 0-400GPM to make sure everything was registering correctly in my input card.
I also cleaned the electrodes in the meter they where very dirty. After confirming all signals and cleaning I still could not get the totalizer to repeat any totals. Sometimes it was spot on , some times it is 72 gallons less than spt. and some times 90gallons more than spt.
I believe i'm going to switch out the flow meter and see if it helps. I may even try setting up the meter for pulse. I'm completely out of options. I tried periodic task, etc.
Dr.bit boy i appreciate all your help, but some of the examples are bit over my head. I have used the GSV instruction. But i'm not 100% following what you have listed as examples. Unfortunately i don't get to work with logic all the time and it puts me behind.
I appreciate all the help!