Dears
I have cold roll coil and need to control it after rewinding using any analog sensor to detect edge position and then send its signal to servo Valve to move recoiler motor base to rewinding it again in FLAT mode position all i have is PLC Siemens 414 system and i have edge detector i need to fully control detector signal using plc in other hand i am looking for another public edge detector to hand made all system
how can i scale analog signal from detector and send it again to Servo valve to be fully control?
I have cold roll coil and need to control it after rewinding using any analog sensor to detect edge position and then send its signal to servo Valve to move recoiler motor base to rewinding it again in FLAT mode position all i have is PLC Siemens 414 system and i have edge detector i need to fully control detector signal using plc in other hand i am looking for another public edge detector to hand made all system
how can i scale analog signal from detector and send it again to Servo valve to be fully control?
Last edited: