I have been searching the forum looking for information on this. I would like to find a flame controller , Honeywell , White/Rodgers , etc. that would allow me to interface with it to see the flame signal strength ( Analog ) , status of interlocks , etc. even by Ethernet if possible. I seen this reply by Dan W. in May of 2013
"This is flame safety, period. If you are not qualified at the design level of flame safety controllers, you should not be doing this. Buy it, don't design it. Flame safety controllers are readily available in the market place."
I just have not seen anything that you can just capture this data remotely , etc. I would like to take this into a PLC so I can display on a HMI , etc. Have any of you seen anything on the market , Honeywell , Eclipse , etc. ?
Thanks so much
"This is flame safety, period. If you are not qualified at the design level of flame safety controllers, you should not be doing this. Buy it, don't design it. Flame safety controllers are readily available in the market place."
I just have not seen anything that you can just capture this data remotely , etc. I would like to take this into a PLC so I can display on a HMI , etc. Have any of you seen anything on the market , Honeywell , Eclipse , etc. ?
Thanks so much