Hi,
im familiar only with Siemens PLC, and now im doing commissioning in unity pro project.
So question is that how do I force an analog output in unity?
Analog card is 140 ACO 020 00, and im pretty sure that straight from the module its not possible.
I was trying to use the device DDT value, but it didn't work out. I didn't figure out the correct address for that.
very grateful if somebody can help me with this.
Best regards,
kabou
im familiar only with Siemens PLC, and now im doing commissioning in unity pro project.
So question is that how do I force an analog output in unity?
Analog card is 140 ACO 020 00, and im pretty sure that straight from the module its not possible.
I was trying to use the device DDT value, but it didn't work out. I didn't figure out the correct address for that.
very grateful if somebody can help me with this.
Best regards,
kabou