I need to configure a very old RTU50, it is the precursor to he SCD5200, what software is used to configure these?
The only information that I can find is this which says FoxRTU to configure it using something that looks similar to isograph however I suspect the RTU50 requires something older again.
http://iom.invensys.com/EN/Pages/Foxboro_SCADA_Hardware_PowerRTU-SCD5200.aspx
Anyone know what the name of the software package that RTU50 uses and where I might get it at short notice?
edit: Apparently similar to a SCD6000
Here is the RTU 50 brochure
http://resource.invensys.com/iaseries/pss/31h8/31h8k6.pdf
http://resource.invensys.com/iaseries/pss/pss3/start.asp
The only information that I can find is this which says FoxRTU to configure it using something that looks similar to isograph however I suspect the RTU50 requires something older again.
http://iom.invensys.com/EN/Pages/Foxboro_SCADA_Hardware_PowerRTU-SCD5200.aspx
Anyone know what the name of the software package that RTU50 uses and where I might get it at short notice?
edit: Apparently similar to a SCD6000
Here is the RTU 50 brochure
http://resource.invensys.com/iaseries/pss/31h8/31h8k6.pdf
http://resource.invensys.com/iaseries/pss/pss3/start.asp
Last edited: