Hi,
I have an old Giddings & Lewis Pic900 Turbo PLC system with a serial card connected to a GE (cincinnati electronics) (Greyline) 3415 using Series Two comms protocol.
I'm looking to replace the HMI with something, either an HMI or SCADA system depending if a comms driver is available.
I may have to create a simple driver using a SCADA system with serial comms just wondered if somebody has done this before, or better still has the Series Two protocol details??
I've had a serial comms Analyzer running and can see the ASCII commands i think being passed both ways???
Has anybody used a modern day device on the back of an Giddings & Lewis PLC?
any info would be great
thanks folks
I have an old Giddings & Lewis Pic900 Turbo PLC system with a serial card connected to a GE (cincinnati electronics) (Greyline) 3415 using Series Two comms protocol.
I'm looking to replace the HMI with something, either an HMI or SCADA system depending if a comms driver is available.
I may have to create a simple driver using a SCADA system with serial comms just wondered if somebody has done this before, or better still has the Series Two protocol details??
I've had a serial comms Analyzer running and can see the ASCII commands i think being passed both ways???
Has anybody used a modern day device on the back of an Giddings & Lewis PLC?
any info would be great
thanks folks