help citect scada io problem

[THIRDFOOTS]

hi all

I am trying to do my first project with scada .I have a book that is explains some of the how to`s
but ..... i have hit a problem ....i have attached a screen shoots what is coming up.

can you see a problem with what i have done here ?

your help with this will be greatly appreciated

 

[BobB]

Address is incorrect.
What is your I/O device?
Is it and Omron PLC?
If so you may have to use DM instead of D.
​

 

[THIRDFOOTS]

Address is incorrect.
What is your I/O device?
Is it and Omron PLC?
If so you may have to use DM instead of D.
​

hi bob
thanks for the reply

do you need a i/o device configured to compile the file?
i have not done that yet
no the plc will be a ab of some sort
but i will give dm a go

dose D need to be in upper case?

 

[BobB]

do you need a i/o device configured to compile the file?
yes
i have not done that yet
no the plc will be a ab of some sort
you will have to configure your I/O device so that Citect knows which driver to use and the addressing for the PLC model
but i will give dm a go
Check the Citect help file for the driver as to which memory areas of the PLC can be addressed and the correct addressing format to use

 

[THIRDFOOTS]

ok thanks for your help...
i did not fix the problem ....
but what i did was went back and started from the start.
what ever i did last time i did not do this time and the program worked.
i will spend some time on the other program and see if i can get it to work my challenge for the week...